7435A REV D Norge Dryer Parts List

Upper drum glide (use 5303937139)

The upper drum felt glide kit helps to support the front drum as it rotates smoothly and quietly while operating. This kit includes three glides with the adhesive. If your dryer won’t tumble or is noisy, the glide could be worn down causing you to hear a metal on metal noise and will need to be replaced. The drum glide is a genuine OEM part and sold individually. Please remember to disconnect the power to the dryer before starting your repair.

Rear drum bearing kit (shaft bracket asm)

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Over time the drum bearing will wear out, once it has the dryer may make some noise and the drum bearing will need to be replaced. This kit will help keep your dryer running as smoothly as possible with as little noise as possible. This is a genuine OEM part. Please remember to disconnect the power to your appliance before starting your repair.

Door shelf bar (shelf fixed ff)

This shelf is designed to fit a refrigerator. It connects to the refrigerator door, and is used to hold food and beverage items. It is made of white plastic and is approximately 24 inches wide. The door shelf should snap directly into place. This part will be required if your old shelf is cracked, broken or missing.

Tine pivot

This tine pivot clip helps hold the tine row in place on your dish rack. If your clip is broken or cracked, you should replace it. This clip is made from plastic and is a genuine OEM part. It is sold individually.

Upper spray arm (Frigidaire dishwasher upper spray arm)

The upper spray arm helps distribute water from the top of the dishwasher tub. The spray arm spins on the upper support when the dishwasher is running. If the spray arm is cracked, broken, or clogged with no water coming from the spray arm, your dishes may not be cleaned properly and the upper spray arm will need to be replaced. The spray arm is 9-inch long, gray in color and made of plastic. This is a genuine OEM part. Please remember to disconnect the power and water supply to your dishwasher before starting your repair.

Bearing slide (bearing slide veg. Frame)

Sold individually.

Dryer timer (timer plas. Shaft)

Drip bowl - 6 inch (stove top chrome drip bowl (pan) for 6 inch electric heating element. This drip pan sits underneath the burner to catch drips or spills.)

This six inch chrome drip bowl is intended for use with tilt lock style surface mount burner element units.

Drive belt - 51 inches long

This V-style drive belt is about 51-inch long and 3/8-inch wide. This part is made to slip onto the motor pulley to bring the basket up to the speed required. The belt encounters wear and tear over time. If your washer will not drain, spin, or agitate, you may need to replace your belt. It is recommended to disconnect the power to your washer before you start your repair. This V-style belt is a genuine OEM part.

Top burner igniter

This top burner igniter has a male spade terminal. It is used to create a spark that will light the gas and start the burner when the burner knob is depressed and turned. The mounting bracket is included with the igniter. If your element will not heat, will not start, or the gas igniter glows but will not light, you may need to replace the igniter. This is a genuine OEM part. It is recommended to disconnect the power to your range before you start your repair.

Front load washer door lock and switch assembly (door lock/switch assy)

Torx screw (screw-torx)

7-18 x 3/4" - sold individually.

Defrost heater harness kit (heater harness def asm)

This dual heater kit replaces the single heater. It's redesigned to use two heating elements for a better defrost cycle.

Sealed burner cap with electrode (sub 12500099)

This burner cap assembly is sold with the spark electrode. Please note this part has been redesigned and no longer requires a gasket. Sold individually.

Door mullion spring (spring etc french)

The French door divider spring fits most Samsung French door style refrigerators. The spring applies tension between components in the refrigerator, which engages and retracts the door flap. This will allow the door to close properly. If the spring is broken, damaged, or faulty the door flap will swing open and block the door from closing, and you should look to replace the part straight away to prevent further damage to the door. The spring is a genuine OEM part, is made of metal, and measures at 1 1/2" long. This part is also known as a refrigerator door mullion spring.